2004 FLOW IFB4800

Pre Owned late 11-1-2004 Flow Integrated Flying Bridge IFB 4800 CNC Waterjet Cutting System This waterjet is very low hours 2013 hours on machine. This machine set for several years before it was put in service in 2013. The computer was upgraded, Windows XP installed running Flow Cut 6.7 with Layout and Nesting Software. The machine had both new X axis bellows installed Machine was upgraded in 2013 to machine Specifications at that time of install. The Cutting Tank was sandblasted and epoxy coated. It is a very nice looking machine. The machine is set to run on 240v three phase and needs 100 amps. It can be set back to 480v The Triplex pump was just rebuilt with less than 20 hours on it. Machine is hooked up and running right now. The machine works flawless and would make a very nice machine for anyone. You can install and go right to work. Machine needs nothing and works great. GENERAL SPECIFICATIONS
Cutting Area 4’ X 8’
Intensifier Output 55,000 PSI TRIPLEX Direct drive pump
Motor Size 30 HP
Z-Axis Adjustability 8"
Contouring Speed 300 IPM
Traverse Speed 0-500 IPM

EQUIPPED WITH
Flowmaster 6.7 PC Based CNC Control Phaser ECL cutting head
30 HP Intensifier Triplex direct drive Pump (240 three phase Volt, 100 Amps) ( can be set back to 480 three phase)
Hopper Comes with a complete Water Veyor system. It is not installed at this time. It will need some work getting it going. System is complete.
For further information please call Harvey Geller at 714-968-9985