2002 OMAX 55100

OMAX 55100 WATERJET

NEW 2002

Machine Dimensions
Footprint (with controller) 155" x 94" (3,937 mm x 2,388 mm)
Weight (tank empty) 8,000 lb (3,629 kg)
Height (with scissor plumbing) 118" (2,998 mm)
Operating Weight 22,000 lb (10,000 kg)
(with water in tank)
Work Envelope
X-Y Travel 100" x 55" (2,540 mm x 1,397 mm)
Table Size 126" x 65" (3,200 mm x 1,650 mm)
Material Supported Slats 4" x 1/8" Galvanized Steel
Maximum Supported
Material Load 400 lbs/sq ft (1,950 kg/sq meter)
(Optional accessories may reduce travel. Contact OMAX for information.)
Computer Control System
Hardware Personal computer
Control Software Integrated CAD/CAM system directly uses DXF files
Drive Description
• Closed loop, digital drives
• Brushless servo motors
• Pre-loaded ball screws, recirculating ball bearings
• Linear bearings with hardened, precision ground ways
• Cantilever Y-axis on bridge X-axis
Accuracy of Motion at 70° F
Ballbar Circularity (Over 12")
At Max. T
raverse Velocity ±0.003" (±0.08 mm)
Repeatability ±0.002" (±0.051 mm)
Squareness 0.002" per ft (0.17 mm/m)
Straightness 0.003" per ft (0.25 mm/m)
Backlash 0.0007" maximum (0.018 mm)
Speed
• 180 inches per minute standard (4,572 mm/min)
Electrical Requirements
• 3-Phase, 380-480 VAC ±10%, 50-60 Hz
(Note: Contact OMAX for detailed utility requirements. Pumps are built to meet
UL and CE specifications.)
Pump Options
• 30 horsepower,
55,000 psi (3,850 bar)
• 40 horsepower,
55,000 psi (3,850 bar)
Noise Level
• Below 80 dBA at 1 meter for submerged cutting

Equipped with:

. 40 Horsepower
. Tilt-A-Jet
. New Controls *

* The machine is in Great condition as far as servo's and the pump are concerned.
It ran for only one week before the power surge melted the controller. Due to a power outage that caused us to loose one leg of the 3 phase power and the transformer was incorrectly wired and allowed the ground to feed back through basically.

For further information please call Harvey Geller at 714-968-9985