80 MM CANMOLD EXTRUSION BLOW MOLDING MACHINE MODEL CAN80R2 MFG 2015
ConditionUsed
1 available
80 MM CANMOLD EXTRUSION BLOW MOLDING MACHINE MODEL CAN80R MFG 2015
Linear carriage for the platens and bobbing head for the machine
- 80 MM Extruder 24:1 L/D producing 12L in single cavity
- Extruder motor power 30 kw
- 4-barrel heat zones on the extruder
- 30-point Moog parison programmer
- triple head 120 mm CD
- View stripe extruder system to run on the five x 100mm CD head
- Pre-squeeze pinch knife
- Voltage: 380V, 3P, 60C
- Clamping force – 115 kn
- Platen dimensions – 520mm x 420mm (w x h)
- Platen opening 200-560mm
- Blow pin stroke 180 mm ( NOTE BLOW PINS NOT INCLUDED )
Fully adjustable blow pin station horizontall with vertical fine adjustment
set up for deflashing ( hardware is not included )
includes : horizontal Scrap conveyor to remove the flash from underneath the machine and transport to the incline conveyor
wrap around conveyor
48 OZ F-STYLE MOLDS
Two dual cavity inserted with beryllium copper in shoulder and base pinch areas. Backplates hard anodized, with mold trim tooling
(2) dual cavity blow molds
(2) dual cavity can mold trim and transfer
3 OZ OFFSET NECK OIL MOLDS
Two five cavity molds. Built in common block at 100 mm centers, inserted with beryllium copper in shoulder. Backplates hard anodized, mold trim tooling
(2) penta blow molds
(2) penta station trim and transfer
We use cookies to improve your experience. Privacy Policy.