2012 MGS INJECTION UNIT UMS-10M

(1) USED MGS INJECTION UNIT MODEL UMS-10M MFG 2012

SPECIFICATIONS:
INJECTION STROKE; 1.97"
INTENSIFICATION RATIO : 21,875
PLASTIC PRESSURE @ SYSTEM PRESSURE 26,250 PSI
SHOT SIZE . 0.089 OZ
The injection unit had a combo plasticizer (12mm screw/ 8mm plunger) Screw section (feed) is 12mm; feed difficult if pellets are not small or consistent enough to gravity drop into screw flights. Melt routed in-line through ports into a 8mm plunger with ball-check
Closed loop injection speed & pressure control
injection speeds, 3.0 inches/second maximum velocity
hold pressures
Open loop screw speed
back pressure
Nozzle position Z axis (vertical) controlled at operator interface panel
Easy to set nozzle touch and sprue break set points
Allen-Bradley Programmable Logic Controller Mold Mount Injection Unit
Phone Modem for Program Support
Color Touch Screen Operator Interface
Convenient data entry and monitoring
Quality Monitoring Screen
Tool Steel Screw and Barrel
Independent Hydraulic System
Variable Volume & Pressure Control, 20’ hose and cable length.
SPI interface, for communications with base machine
32 pin interface connector Hydraulic Unit
3 heater zones
• 2 set points per zone, Run and Standby
• 2 operation modes, Automatic and Manual
• Individual circuit breaker protection